💾 Your circuit is saved in your browser as you go (and included when you back up your data). In a live room, it's kept on our server so others can join, and is deleted after a week with nobody in it.

How it works & questions

How it works

  1. 1

    Add a breadboard and parts

    Resistors, LEDs, buttons, chips like the 555 and 74HC series, an Arduino Uno, sensors and modules. Make your own part for anything missing.

  2. 2

    Wire it up

    Drag from one hole to another to add a wire. Hover any hole to see everything it's joined to.

  3. 3

    Fix the mistakes

    It points out shorts, LEDs with no resistor, parts in backwards and chips with no power, then gives you a parts list and a picture for your report.

Questions

Does it simulate the circuit?

Not yet. It checks how everything is connected and flags the common mistakes, which catches most problems before you build it.

What if my chip or sensor isn't in the list?

Press New part under My parts, type its name and its pin names in order, and it's added as a chip or a module. The checker understands pins called VCC, 5V, 3.3V and GND.

How are the rows joined?

Like a real breadboard: each column of five holes (a–e and f–j) is joined, and each rail along the top and bottom is joined. Hover a hole to see it.

Can my group work on it together?

Yes. Start a live room and send the link. Everyone edits the same circuit.